Hot summer washing equipment cleaning and maintenance work to do

Is undoubtedly the best helper in the hotel laundry washing equipment, but if you are bad for it, it also becomes very "rebellion" at any time, do not listen to your boss, such as clothes not clean, or a loud "protest" and so on, so use in the process, you can not ignore the "feeling" of the washing machine, be careful, to make it provide a better service.
Laundry staff before work, in addition to the washing equipment clean both inside and outside, and close the door, even make a cover on the outside.Little imagine, closed washing equipment of machine door against the residual moisture evaporation, also easy to mildew, endanger the health of the hotel customers.
 Washing equipment cleaning and matters needing attention:
1, washing clothes, must put out all the water in the washing machine and open air, in order to avoid the remaining water inside the machine form microbial breeding grounds.
2, drainage pipeline had better use clean water to wash after each use.
After 3, top open the door of the washing machine used to dry water inside with dry dishcloth, side door of the washing machine in addition to dry the water from the washer mounted on the door, lest cause mould.
4, stored in a ventilated dry place, avoid in a bathroom.
5, the drain must be higher than the drainage pipe, water can not be left in the drainage tube.
6 and when not to pick the filter bag hanging outside and let it fully dry.
7, immediately take out dry washing the clothes, do not stuffy inside.
Washing equipment daily maintenance
1, long stored washing equipment should be covered with plastic film or cloth cover, avoid the erosion of dust, keep washing equipment light, clean and tidy.
2, 2, 3 months to boot commissioning, prevent rust parts, motor winding be affected with damp be affected with damp.Electricity is also a means of drying winding, can avoid stopping time is too long and cause failure.
3 do not exposed to direct sunlight for a long time, washing equipment, especially for plastic parts, so as not to fade, aging.
4, washing equipment, stopped for a long time, to rule out water, keep clean and tidy.
5, should be placed in dry, no corrosive gas, no strong acid, strong alkali erosion, so as to avoid the rust of the metal, electrical components to reduce the insulation performance.
6, no oil injection hole to wave wheel washing machine, should give the washing machine oil once, in case of rust.